The DB9F-TO-TB/10 Adapter is plugged into a serial connector DSub-9 male, like Com1 on a PC. The signals located on the Pins then are available on the clamps of a Terminal block. The signal location is optimized for RS422/485 serial ports and CAN bus on VScom products. GND, Rx+/- and Tx+/- (Data+/- for RS485) are on the clamps. This also applies to CAN bus CAN_H and CAN_L signals. The housing provides for isolation and strain relief on the cables, additional screws easily fix the adapter to a DSub-9 male connectors. Use without housing is possible for frequent access to the terminal block.
Terminal Block Adapter, converts DSub-9 male to 10-clamp Terminal block. Accessory for Serial Device Server or USB to Serial Devices (Industrial Plus Line) The 10-clamp allows use of CAN bus cables as well.
You can purchase VSCOM's products easily from a wide variety of leading technology distributors or partners.
Please call us or contact us by mail to find the best ordering method for your needs.
* Specifications are subject to change without notice.
* All the trademarks and brands are property of their rightful owners.
BUY 
